This worked, somehow in a fuck this worked. But speed is slow maybe that is because of signal strength but It does connects and sites tries to load
1 Like
Dont close the topic just yet I am nit sure if this will work let me try with mobile hotspot
Yep It works fine Im typing this through wifi on my system thank you both very much, Ill now make 30 backups of that driver and try it on a live usb if this will always work but It work on here thank you very much guys I paid 8$ for this and thats a lot for me even though my system is little high end.
1 Like
$8 is pretty good. Is it working okay now?
Fine as fiddle. I think you can close this topic now I dont think I will get into problem though is there any way I can load module right into kernel without rebooting I want to try it on a live system before I am truely satisfied, I dont wanna install another system now, did many in past few days.
I don’t think so. If it works then should be okay.
1 Like
My bad, I found it here :
For V2 & V3 see: rtl8192EU Linux Driver Installation
Instead for the Legacy V1: It should work Out-of-Box with the bundled rtl8xxxu Module.
I had the same problem with my interface, it was a bit slow, it was more because of the reception sensitivity than the signal strength.
1 Like
Yes on this site it say’s v1 should work out of the box with the kernel module rtl8xxxu. V2 v3 use rtl8192eu. Problem is it’s not always known what version the chip may be. I just go by the hardware it shows and look it up as best i can. I use a lot of TP-Link cards but they ALL have broadcom chips and they are internal Pci-e cards for desktop. If i am going to purchase a usb i look at what WiFi standard it supports. They do not tell you what chip it has. You can only determine that by plugging it in and getting the info. I try to get one that supports more updated standards. No less than 802.11 AC Anything i would purchase today would be 802.11 AX for the most part.
1 Like
Ill reinstall system tomorrow and conculisively get back to you
this is the driver that works
I only installed dkms, and then ran install.sh in that repo
also I wont need to restart pc after installing wifi will start working from get go, but I did the installation with usb not plugged in. Thank you guys once again for help I think this is over now though I wonder why did it not work before.
This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.