Hi, seems this bug is still sleeping here :frowning: Did a full update yesterday on my main machine (pacman only) and then tried to boot the lts-kernel. It’s installed from ISO version 2025.03.19 Same problem as described in the thread here. Has been before the same. dracut --version → dracut 10…

1 endeavouros/dracut 108_eos-1 (576.2 KiB 1.5 MiB) (Installed) An event driven initramfs infrastructure Is this installed??

# pacman -Qs dracut local/dracut 108_eos-1 An event driven initramfs infrastructure local/eos-dracut 1.7-1 Dracut scripts and hooks for EndeavourOS have done # pacman -Syu just before my tests… That’s no solution - the problem persits :frowning: cannot boot the lts-kernel. See the …

[image] Perhaps you could get that file. It may reveal something interesting.

The only thing I can do here is a cold reboot / switch off. No input possible. And on my disk I will find nothing, I think, because /run is in RAM located…

You should be able to enter the password. It will look like nothing is happening.

[image] wolfn: The only thing I can do here is a cold reboot / switch off. No input possible. Normally you could give your root password at that prompt to get into a root shell. If you say no input is possible, I don’t know why.

Thats what I expected, too. Nope. Will try the password once again… Edit: No password, no CTRL-D accepted. Dead. Edit2: Don’t know, if it will matter: I’m using efi-stub for booting (rEFInd), no grub or systemd. But, as already said - default-kernel has no problem…

Have you tried running sudo dracut-rebuild

Sure, 2 or 3 times… But could not use the other initrd, the same stop. From running default-kernel only.

EndeavourOS

Failed to mount /sysroot during boot

General system Kernel, boot, graphics & hardware

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled