Can't boot into pc after installation

General system Newbie
1

Hello, so i installed endeavor on a VM before installing it on my actual hardware and there it went fine but now that i’ve installed it on my real hardware it doesn’t boot and i get stuck on a black screen after restarted the pc as it says at the end of the installation. The black screen occurs after some kernel module loop. I’ve tried switching from grub to systemmd as my bootloader, using ext4 instead of brtfs, messing with the terminal stuff from the help of a few people in the discord but nothing’s worked.

im currently in the live environment and cant use windows because i erased the drive windows was on to make room for endeavor. Any help is greatly appreciated!

2

Do you have an nvidia card? I recently had the same issue. Take a look at this thread. New install - Black screen.

TLDR - Try using the live usb to chroot and run nvidia-inst.

3

yeah i do have an nvidia card. i’ll look into this thread and see if helps, tysm mate!

4

after reading through the thread i still dont understand much. could u help get into this chroot thing?

5

This will help you use chroot. Unfortunately, I can’t give you the commands because they depend on the choices made when installing.

https://discovery.endeavouros.com/system-rescue/arch-chroot/2022/12/

6

i found that awhile back but i didn’t understand much from it so that’s why i contacted the forum. i could install endeavor just as u recommend or i could just list out all the changes i made so that u could guide me on how to use chroot

7

this worked mate tysm!

8

This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.