For my Nvidia driver https://aur.archlinux.org/packages/nvidia-470xx-dkms the pinned message recommends this https://github.com/korvahannu/arch-nvidia-drivers-installation-guide guide. Followed every instruction just one question https://github.com/korvahannu/arch-nvidia-drivers-installation-guide?…

I’m not sure about all that, to be honest. I used nvidia-inst to install drivers. It worked quickly and without issues. [image] Nvidia-inst news Announcements and news Here’s the news stand for the nvidia-inst app. nvidia-inst is a driver installer for Nvidia…

For dracut all you have to do is add a file under /etc/dracut.conf.d with something like the following in it. force_drivers+=" nvidia nvidia_modeset nvidia_uvm nvidia_drm " Then you have to generate you initramfs, but I think the EndeavourOS installer already does that for you?

ThankYou I’ll test. Then you have to generate you initramfs, but I think the EndeavourOS installer already does that for you? As mentioned in the guide, I’ll do that anyway ;D dracut-rebuild

How do I install nvidia-inst ? Seems not available in official or AUR repo.

If you have installed latest release, it should be installed already.

Yes I’m on latest but most likely not upgraded from latest EOS iso.

Then you should be able to use it though terminal. I’m not certain what you mean “not upgraded”. EOS is rolling-release (because Arch) so system should be “upgraded” if you have installed it.

nvidia-inst -h bash: nvidia-inst: command not found package not installed. Is it provided from EOS repo? I remember I used to have this but probably I removed at some point (~2 years ago) Installed it again sudo pacman -S nvidia-inst

Early Loading of NVIDIA Modules for Dracut

General system Kernel, boot, graphics & hardware

UncleSpellbinder May 7, 2025, 3:44pm 2

I’m not sure about all that, to be honest. I used nvidia-inst to install drivers. It worked quickly and without issues.